Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - _FIII

Pages: [1] 2 3 ... 36
1
Smith-Roles / Re: Clem Roles
« on: May 06, 2020, 10:56:47 am »
That’s too bad.   

2
Comanche / Re: comanche seat
« on: May 06, 2020, 10:53:55 am »
Nice seat!  Looks comfy

3
Wanted / Re: Rockwell piston
« on: December 13, 2019, 08:08:41 am »
Have you checked with suppliers?

Arctic Restorations or Jerry’s NOS cat parts. 

Try Sno World in Yorkton, Sk too

4
Apache / Re: Apache 433 won’t run
« on: December 03, 2019, 02:28:02 pm »
Do a search on vintagesleds.com for yamaha wiring.  Lots of info there and should be the same for 338 and 433 motors

5
GT Series / Re: just making sure this is a 72...
« on: December 03, 2019, 02:24:04 pm »
Yes that’s a 72

6
GT Series / Re: 72 GT 433R
« on: December 03, 2019, 02:23:01 pm »
I’m not sure how many were built but the 72’s don’t seem super common.  All then do you were given is correct

7
Roll-O-Flex History / Re: Cool Finds
« on: December 03, 2019, 02:21:54 pm »
Very cool!!

8
Wanted / Re: 1970 PT Wild One
« on: April 21, 2019, 08:15:09 pm »
also check for Boa Ski stuff because they are the same

9
where are the parts located?

there are Roll-O guys all over and there may ne one close to you who is looking for parts

10
PT Series / Re: 1970 PT Wild One - Interchangable parts
« on: February 24, 2019, 08:32:11 pm »
the sleds in 1969 and 1970 were built by Boa Ski so parts should be easy to find.  The chain case will actualy say boa ski in the casting of the cover

11
Welcome Area / Re: Greetings
« on: February 24, 2019, 08:30:22 pm »
very nice sled!

for some reason 1972's seem to be the least common.  I don't see them very often

12
Welcome Area / Re: My sled
« on: March 08, 2018, 06:38:30 pm »
very nice survivor sled!  Don't see to many of the wide track cherokee

13
Announcements / Re: Gene Glaze, co-founder of Roll-O-Flex, passed away
« on: November 22, 2017, 05:27:47 pm »
I am very honoured to have met and talked with Gene over the years since I started collecting Roll-O-Flex snowmobiles.  I was going to start the restoration of his SnoPro sled to have it on display next summer in hopes that I could reunite him with his machine.  Sadly this will not be possible but the restoration will continue in his honour.  

Here is a great picture of him and Wade at my place in 2011.


14
Comanche / Re: Parts for Roll-A-Flex
« on: October 30, 2017, 04:22:34 am »
I should have a wiring diagram for you

15
Welcome Area / Re: new member , 1st roll o flex
« on: October 30, 2017, 04:17:14 am »
Hard to tell without a better look at the hood but I would say that you have yourself a 73 or 74 GT.

The GT's all had the dual exhaust from 72-74 and dual carbs in 72.  The suspension is the stock "super flexion" skid and is nothing optional, so to speak.

Nice sled and good luck with the restoration

Pages: [1] 2 3 ... 36