Pages: [1]   Go Down
Print
Author Topic: tracks and cylinders  (Read 2095 times)
srxyamiman
Newbie
*

Karma: +0/-0
Offline Offline

Posts: 28


View Profile
« on: October 05, 2009, 09:14:12 PM »

Still have not found the right track but am working on an old john dear or massey track.

Second I have 116 inch srx tracks, could i just use smaller front drivers and make this work, and if so would i just change my gear ratio by the same percentage that i went down in driver size?

Lastly. I just bought a 73 gp 292 that i was going to restore, but sled is not really my favorite.  I tore down the engine and it is in need of a complete rebuild.  water in bottom end...... Cylinder is measuring 72.75mm

What is the stock bore for a 292?
Could i put this cylinder and carb on my apache and make it a ss? Or in yamaha talk is the cylinder and single ring piston the only difference in the 292's?
Logged
Pages: [1]   Go Up
Print
Jump to: